Piggy60

A gasket-mounted 60% in the style of the S7 Elephant.

Keyboard Maintainer: The QMK Community
Hardware Supported: Piggy60 PCB "rev1" (atmega32u4)
- Make sure your PCB uses an atmega32u4 before flashing! A PCB that uses an APM32F103CBT6 with uf2boot has been shipped with some extras purchases and to replace some defective units. Flashing that PCB with "rev1" firmware may result in a non-functional PCB which can only be recovered using a hardware programmer (e.g. an ST-Link V2)
Hardware Availability: Group Buy took place between 2021-05-22 1600 UTC and 2021-05-25 1600 UTC on https://jackylab.com/.

Make example for this keyboard (after setting up your build environment):

make jacky_studio/piggy60:default

Flashing example for this keyboard:

make jacky_studio/piggy60:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the top left key and plug in the keyboard. This will also clear EEPROM, so it is a good first step if the keyboard is misbehaving.
Physical reset: Short the set of vertical holes on the third row, to the right of Caps Lock. These can be reached with tweezers after the board has been assembled.
Keycode in layout: There is no key mapped to QK_BOOT in the pre-created keymaps, but you may assign this key in any keymaps you create.