qmk_firmware/keyboards/handwired/snatchpad
2023-01-30 20:45:41 +00:00
..
keymaps/default Deprecate KC_LOCK for QK_LOCK (#18796) 2022-10-21 15:46:10 +01:00
config.h Clean up Force NKRO in config.h (#19718) 2023-01-30 20:45:41 +00:00
info.json
readme.md
rules.mk
snatchpad.c
snatchpad.h

snatchpad

snatchpad etch-a-sketch macropad

A 6-key macropad with 2 rotary encoders intended for use as a pointing device.

In addition to the 3d printed parts and microcontroller, the following hardware is required:

  • 4 * 3x3 mm threaded inserts
  • 4 * 4mm M3 bolt
  • USB daughter board

  • Keyboard Maintainer: xia0
  • Hardware Supported: e.g. Arduino Pro Micro
  • Hardware Availability: github

Make example for this keyboard (after setting up your build environment):

make handwired/snatchpad:default

Flashing example for this keyboard:

make handwired/snatchpad:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available