forked from mirrors/qmk_firmware
.. | ||
kb2040 | ||
keymaps | ||
pro_micro | ||
readme.md |
sweet16v2
A 4x4 macropad with RGB inswitch lighting and underglow.
- Keyboard Maintainer: ziptyze
- Hardware Supported: 1upkeyboards Sweet 16 v2
- Hardware Availability: 1upkeyboards
Make example for this keyboard using an atmel-based controller (after setting up your build environment):
make 1upkeyboards/sweet16v2/promicro:default
Flashing example for this keyboard using an atmel-based controller:
make 1upkeyboards/sweet16v2/promicro:default:flash
Make example for this keyboard using an rp2040-based controller (after setting up your build environment):
make 1upkeyboards/sweet16v2/kb2040:default
Flashing example for this keyboard using an rp2040-based controller:
make 1upkeyboards/sweet16v2/kb2040:default:flash
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader
Enter the bootloader in 3 ways for atmel-based controllers:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
- Keycode in layout: Press the key mapped to
RESET
if it is available
Enter the bootloader in 2 ways for rp2040-based controllers:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Bootsel button: Hold the bootsel button on controller and plug in the keyboard