qmk_firmware/keyboards/yandrstudio/zhou65
Ryan ebb512db82
Debounce defines cleanup (#19742)
* Clean up `DEBOUNCE` in config.h, 0-9

* Clean up `DEBOUNCE` in config.h, A

* Clean up `DEBOUNCE` in config.h, B

* Clean up `DEBOUNCE` in config.h, C

* Clean up `DEBOUNCE` in config.h, D

* Clean up `DEBOUNCE` in config.h, E

* Clean up `DEBOUNCE` in config.h, F

* Clean up `DEBOUNCE` in config.h, G

* Clean up `DEBOUNCE` in config.h, H

* Clean up `DEBOUNCE` in config.h, handwired

* Clean up `DEBOUNCE` in config.h, I

* Clean up `DEBOUNCE` in config.h, J

* Clean up `DEBOUNCE` in config.h, K

* Clean up `DEBOUNCE` in config.h, L

* Clean up `DEBOUNCE` in config.h, M

* Clean up `DEBOUNCE` in config.h, N

* Clean up `DEBOUNCE` in config.h, O

* Clean up `DEBOUNCE` in config.h, P

* Clean up `DEBOUNCE` in config.h, Q

* Clean up `DEBOUNCE` in config.h, R

* Clean up `DEBOUNCE` in config.h, S

* Clean up `DEBOUNCE` in config.h, T

* Clean up `DEBOUNCE` in config.h, U

* Clean up `DEBOUNCE` in config.h, V

* Clean up `DEBOUNCE` in config.h, W

* Clean up `DEBOUNCE` in config.h, X

* Clean up `DEBOUNCE` in config.h, Y

* Clean up `DEBOUNCE` in config.h, Z

* Remove default debounce from info.json

* Migrate non-default debounce to info.json
2023-02-03 19:19:58 +00:00
..
keymaps
board.h Fixup ChibiOS header inclusion search ordering. (#19623) 2023-01-19 01:05:29 +00:00
config.h Debounce defines cleanup (#19742) 2023-02-03 19:19:58 +00:00
info.json
mcuconf.h
readme.md
rules.mk
zhou65.c
zhou65.h

zhou65 version 1.0

A 65% keys keyboard with rgb (keys). This keyboard use 16mhz HSE and STM32F401 as MCU.

Make example for this keyboard (after setting up your build environment):

make yandrstudio/zhou65:default

See build environment setup then the make instructions for more information.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key which is Escape in this keyboard) and plug in the keyboard
  • Physical reset pins: Short circuit the bt0 and vcc pins on the back of the PCB and plug in the keyboard
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.