qmk_firmware/keyboards/redox/rev1/proton_c/config.h
Duncan Sutherland b1ea30ca7c
Move redox_w into redox (#21448)
Co-authored-by: Ryan <fauxpark@gmail.com>
2024-01-12 22:44:44 -08:00

26 lines
1.4 KiB
C

// Copyright 2022 xerootg
// SPDX-License-Identifier: GPL-2.0-or-later
#pragma once
// //we are using hardware serial, so lets undef the softserial used otherwise
/* serial.c configuration for split keyboard */
#define SERIAL_USART_FULL_DUPLEX // Enable full duplex operation mode.
#define SERIAL_USART_RX_PIN B7 // USART RX pin
#define SERIAL_USART_TX_PIN B6 // USART TX pin
#define SERIAL_USART_PIN_SWAP // Swap TX and RX pins if keyboard is master halve.
// Check if this feature is necessary with your keyboard design and available on the mcu.
#define SELECT_SOFT_SERIAL_SPEED 1 // or 0, 2, 3, 4, 5
// 0: 460800 baud
// 1: 230400 baud (default)
// 2: 115200 baud
// 3: 57600 baud
// 4: 38400 baud
// 5: 19200 baud
#define SERIAL_USART_DRIVER SD1 // USART driver of TX and RX pin. default: SD1
#define SERIAL_USART_TX_PAL_MODE 7 // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 7
#define SERIAL_USART_RX_PAL_MODE 7 // Pin "alternate function", see the respective datasheet for the appropriate values for your MCU. default: 7
#define SERIAL_USART_TIMEOUT 20 // USART driver timeout. default 20