Make all of the pins bidirectional, and support sending signals when
software drives the pins as outputs.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
When the mask a/b MMRs are written, the output signal might change levels
(as pins are [un]masked), so make sure we update the output level.
Further, make sure we handle edge ints correctly by first sending a high
signal followed by a low signal.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
Makes it a lot easier to find out what's going on with interrupt lines
if the ports have tracing output.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
We need the DIR bit cleared, not set, in order for the pin to be treated
as an input.
When looking up the data value, we need to shift the "level" value over by
"my_port" rather than "bit" as the latter has already been shifted over.
We also should normalize the "level" coming in from the outside worlds to
the set of {0,1} since those are the only values that matter to GPIOs.
We need the BOTH bit set, not cleared, in order for the pin to trigger
on both edges.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
The clear/set/toggle MMRs aren't backed by "real" data; they implicitly
perform bit operations on the associated data register. So when we go
to process writes to them, we need to adjust the pointer accordingly so
that the actual backing data is modified.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
When I originally wrote the w1c helper funcs, I used it in a few places.
Then I forgot how it worked and when I later documented it, I described
the 3rd arg in the exact opposite way it is actually used. This error
propagated to a bunch of devices registers that were not explicitly
tested (a bunch of the devices are stubs which merely exist to say "no
device is connected" to make device drivers happy).
So once the documentation is unscrewed, fix all of the broken call sites.
Signed-off-by: Mike Frysinger <vapier@gentoo.org>
